Zhengzhou corn processing equipment, factory direct price of corn processing equipment] [corn deep processing machinery belt conveyor rack rack rack installation is started from scratch, and then install the sections sequentially intermediate frame, the final installation of the tailstock. Before installing the rack, the first full length of the conveyor pulling the central line, due to the central line to keep the conveyor belt in a straight line is an important prerequisite for normal operation, so when you install the rack sections, it is necessary Align the center line, but also to put on airs leveling, corn deep processing machinery racks on the central line of the promised error per meter captain of ± 0.1mm. But the length of the conveyor frame on the central error should not exceed 35mm. When all the single install and pinpoint can then be connected to each block. My company mainly produces: Corn processing machinery, wheat flour machinery, sorghum, corn peeling machine, product quality and performance have reached international advanced level of similar products. I am in research and development on the basis of wheat flour grade, in 1995 developed the first deep processing of corn, grains processing, wineries crushing and corn off the billet billet mention equipment, becoming the first corn, grains processing machinery production base. Install drive unit, must pay attention to make corn deep processing machinery belt conveyor belt conveyor drive shaft and the vertical center line of the drive roller conveyor width and the center of the center line coincides with the axis of the drive shaft reducer parallel lines. Also, all shafts and rollers should be leveling. Axis horizontal error, according to the width of the conveyor, agreed to within the range of 0.5-1.5mm. Driving means installed at the same time, the tail wheel, etc. can be mounted tensioning device, the tensioning device of the axis of the drum, should the belt conveyor perpendicular to the center line.